Abstract
Swards of three strains of subterranean clover (Seaton Park, Yarloop, Midland B) were subjected to a range of defoliation treatments. In all strains, cutting at weekly intervals at a height of 1.5–2 cm from 1 month after sowing until the onset of flowering led to a slight delay in flower initiation but the time of flowering was little affected. The rate of inflorescence production, however, was always increased, as was the total number of inflorescences produced by the end of flowering. In particular, seed yields were increased by at least 30% compared with uncut controls. This effect was attributable partly to increased inflorescence numbers and partly to increases in other yield components as a consequence of the burial of a large proportion of burrs. Cutting increased the initial level of hard-seededness in Seaton Park and Yarloop; in addition the rate of breakdown of hard-seededness in all strains was slower in seed from the defoliated swards. When cutting was continued until midway through flowering (with the cutting height progressively raised) the seed yield in Yarloop and especially in Midland B was much lower than that obtained when cutting was stopped at the beginning of flowering; but in Seaton Park there was no reduction. With further cutting-until the end of flowering-seed yields were less than when cutting was stopped midway through flowering. Extending cutting into the flowering period (compared with cutting only until the onset of flowering) resulted in a decline in the initial level of hard-seededness and an increase in the rate of breakdown of hard-seededness in Midland B but had little effect in Yarloop or Seaton Park.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.