Abstract
AbstractThe effect of cosurfactant and initiator concentration on theab initioproduction of nanolatexes using low surfactant levels was investigated. While the use of cosurfactants (acrylic acid and pentanol) increased the amount of monomer that can be used in styrene‐SDS microemulsion formulations to 13 wt %, high surfactant concentrations are still required, resulting in polymer‐to‐surfactant ratios (Pol/Surf) <1. Latexes with particle size of 30 ± 5 nm were produced upon polymerization of these microemulsions. The Pol/Surf can be significantly increased by increasing the initiator concentration of emulsion polymerization recipes. Particle sizes are comparable with microemulsion latexes, however, less surfactant is required. The reduction in the particle size with higher initiator concentration is attributed to a higher efficiency of particle nucleation and to a higher nucleation rate relative to the rate of monomer transfer. Nanolatexes (particle size < 30 nm) were obtained with 19 wt % solids content and Pol/Surf of 3.6 inab initio. © 2011 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Polymer Science Part A: Polymer Chemistry
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
