Abstract

BackgroundThere are scenarios where pre-mixing and infusing analgesic and anaesthetic agents as a single intravenous (IV) solution is highly desirable; however, it is important to ensure the agents are compatible when mixed. As such, the long-term stability of a remifentanil-propofol mixture, and means of improving this, were assessed across a range of remifentanil concentrations, diluents, and time points.MethodsRemifentanil was reconstituted with ultrapure water, 0.9% saline, 20% saline, or 8.4% sodium bicarbonate solution (the latter two chosen for their pH characteristics, rather than their use in pharmaceutical reconstitution) and then mixed with propofol (1%) or further diluted with water to derive concentrations of 10–50 μg mL− 1. Remifentanil and propofol concentrations were determined initially and then periodically for up to 24 h using high performance liquid chromatography (HPLC). Mass spectrometry (MS) was used to detect degradation products in solutions containing 30 μg mL− 1 of remifentanil. Statistical analysis was performed using ANOVA and Student’s t-test, with a significance value of 0.05.ResultsIsolated remifentanil (pH < 4) and propofol (pH 7.35) did not degrade significantly when reconstituted with water or saline solution over 24 h, while remifentanil reconstituted with sodium bicarbonate degraded significantly (P < 0.001, pH 8.65). Mixing with propofol substantially increased the pH of the mixture and resulted in significant remifentanil degradation for all reconstitution solutions used, while propofol remained stable (pH 6.50). The amount of degradation product detected in samples containing isolated remifentanil and a mixture of the drugs was proportional to the remifentanil degradation observed.ConclusionsRemifentanil stability is affected by both the reconstitution solution used and when mixed with propofol, with pH appearing to be a contributing factor to degradation. If the pH of the solution and concentration of remifentanil are correctly controlled, e.g. through the use of a more acidic diluent, an admixture of remifentanil and propofol may be useful clinically.

Highlights

  • There are scenarios where pre-mixing and infusing analgesic and anaesthetic agents as a single intravenous (IV) solution is highly desirable; it is important to ensure the agents are compatible when mixed

  • Remifentanil reconstituted with sodium bicarbonate solution degraded rapidly, with no remifentanil remaining after 24 h (Fig. 1)

  • This study demonstrated that the influence of reconstitution medium, pH and drug concentration is important for the stability of a remifentanil-propofol solution

Read more

Summary

Introduction

There are scenarios where pre-mixing and infusing analgesic and anaesthetic agents as a single intravenous (IV) solution is highly desirable; it is important to ensure the agents are compatible when mixed. The long-term stability of a remifentanil-propofol mixture, and means of improving this, were assessed across a range of remifentanil concentrations, diluents, and time points Optimisation of both analgesia and sedation is vital to ensure adequate pain control, minimise agitation and anxiety, facilitate patient compliance for mechanical ventilation or diagnostic interventions, and provide patient comfort [1]. There are scenarios outside of a sophisticated medical facility environment where the availability of specialised equipment may be limited, or many patients must be attended to within a short schedule. It may be advantageous to pre-mix infusion agents and administer them via a simplified, single IV infusion.

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call