Abstract
The different fine particle fractions (FPFs) that are obtained, when different dry powder inhalers (DPIs) are used for the same powder formulation at the same flow rate, is the result of different powder de-agglomeration efficiencies for these DPIs. For adhesive mixtures, this is the efficiency with which the kinetic energy of the air flow through the DPI is converted into separation forces that detach drug particles from carrier crystals. We investigated the effect of drug particle diameter (mass) on drug–carrier separation during inhalation with three different inhalers (Sofotec Novolizer, Inhalator Ingelheim and a special test inhaler), at two different flow rates (30 and 60 l/min). Two different size fractions were used as carrier material (45–63 and 100–150 μm). We measured decreasing amounts of residual drug on the carrier crystals after inhalation with increasing drug particle mass for all inhalers at both flow rates. The observed trends were the same for both carrier fractions. The decrease in residual drug on carrier is in agreement with increasing FPFs in an Erweka impactor. However, it has been calculated that the magnitude of the effect decreases with increasing de-agglomeration efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: European Journal of Pharmaceutics and Biopharmaceutics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.