Abstract
The water resistance of the base coat in exterior insulation and finish systems (EIFS) is critical for overall system performance. ASTM E 331 is used to investigate the water resistance of PB EIFS specimens which incorporate different base coat thicknesses. Test results for specimens with and without finish coat are presented. It was found that PB EIFS base coats in full compliance with recommended application requirements did not allow water intrusion at the industry-specified test pressure of 299 Pa (6.24 lbf/ft2). Based on these test results, observations on the typical failure mode of specimens which allowed water intrusion are presented, and the implications of test results are discussed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
