Abstract
Because a cutting fluid could be equally used for different cutting operations, this study proposed to investigate the behavior of a well-known extreme-pressure additive (pentasulfide) in both turning and milling operations of a steel workpiece. The experimental approach is based on the coupling of mechanical tests (turning, milling, and tribological tests) with physico-chemical characterizations (Auger Electron Spectroscopy and X-Ray Photoelectron Spectroscopy) of the friction surfaces (chip and tool). In the case of milling, it was shown that the presence of a pentasulfide additive has a beneficial effect on the specific cutting energy (kc) and flank wear (Vb). These results are correlated with the presence of iron sulfides (FeS and FeS2) on the flank face of the cutter mill and on the chip face in contact with the mill. No such additive effects are found in case of turning. A lubrication model is proposed for the case of milling based on an indirect lubrication of the tool/workpiece and tool/chip contacts due to the transfer of iron and its reaction with sulfur compounds to produce iron sulfides. Because milling is a discontinuous cutting process, this lubrication mechanism is much more efficient than that observed in turning. Indeed, the tool faces are re-fed iron sulfides each time they leave the workpiece.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.