The effect of adhesive surface with porcelain sintering and two silane coupling agents on the adhesive properties of zirconia.

Abstract

BackgroundTo explore the effect of adhesive surface with porcelain sintering and different silane coupling agents on adhesive properties of zirconia ceramics.MethodsZirconia blocks (n=72) were randomly divided into two large groups (n=36) according to whether the adhesive surface was treated with sintered porcelain: N (no porcelain sintering), P (porcelain sintering). Then, according to different silane coupling agents, each group was randomly divided into three small groups, six small groups in total (n=12): NN (no porcelain sintering and agent), NM (no porcelain sintering + Monobond-S), NC (no porcelain sintering + Clearfil Repair); PN (porcelain sintering + no agent), PM (porcelain sintering + Monobond-S), PC (porcelain sintering + Clearfil Repair). After surface treatment, RelyX Unicem Cement was used to make ceramic-resin bonding specimens. Then, each of the six small groups was randomly divided into two subgroups; shear bond strength (SBS) was tested and bond failure mode was analyzed before and after thermal cycling 5,000 times.Results(I) SBS analysis: the SBS values of the P groups were significantly higher than those of the N groups (P<0.05). The groups treated with silane coupling agents showed higher SBS values than the control group (P<0.05), and the PC groups showed the highest SBS values (P<0.05). The SBS of each group was significantly decreased after thermal cycling (P<0.05). (II) The microcharacteristics under scanning electron microscopy and energy spectrum analysis: the ceramic blocks being treated by porcelain sintering showed more roughness than the control group. A large amount of silicon (Si) appeared on the surface of the ceramic blocks after porcelain sintering.Conclusions(I) Treating the adhesive surface by porcelain sintering can improve the bonding strength between zirconia and RelyX Unicem Cement, and the effect was better in conjunction with silane coupling agent. (II) The two kinds of silane coupling agent (Monobond-S, Clearfil Repair) can improve the bonding strength between zirconia and resin cement. The effect of Clearfil Repair is better than that of Monobond-S. (III) Thermal cycling had a significant adverse effect on SBS between zirconia and RelyX Unicem Cement. Clearfil Repair is helpful in improving the durability of zirconia bonding strength.