The effect of a surface data assimilation technique and the traditional four-dimensional data assimilation on the simulation of a monsoon depression over India using a mesoscale model

Abstract

The objective of this study is to investigate the impact of a surface data assimilation (SDA) technique, together with the traditional four-dimensional data assimilation (FDDA), on the simulation of a monsoon depression that formed over India during the field phase of the 1999 Bay of Bengal Monsoon Experiment (BOBMEX). The SDA uses the analyzed surface data to continuously assimilate the surface layer temperature as well as the water vapor mixing ratio in the mesoscale model. The depression for the greater part of this study was offshore and since successful application of the SDA would require surface information, a method of estimating surface temperature and surface humidity using NOAA-TOVS satellites was used. Three sets of numerical experiments were performed using a coupled mesoscale model. The first set, called CONTROL, uses the NCEP (National Center for Environmental Prediction) reanalysis for the initial and lateral boundary conditions in the MM5 simulation. The second and the third sets implemented the SDA of temperature and moisture together with the traditional FDDA scheme available in the MM5 model. The second set of MM5 simulation implemented the SDA scheme only over the land areas, and the third set extended the SDA technique over land as well as sea. Both the second and third sets of the MM5 simulation used the NOAA-TOVS and QuikSCAT satellite and conventional upper air and surface meteorological data to provide an improved analysis. The results of the three sets of MM5 simulations are compared with one another and with the analysis and the BOBMEX 1999 buoy, ship, and radiosonde observations. The predicted sea level pressure of both the model runs with assimilation resembles the analysis closely and also captures the large-scale structure of the monsoon depression well. The central sea level pressures of the depression for both the model runs with assimilation were 2–4 hPa lower than the CONTROL. The results of both the model runs with assimilation indicate a larger spatial area as well as increased rainfall amounts over the coastal regions after landfall compared with the CONTROL. The impact of FDDA and SDA, the latter over land, resulted in reduced errors of the following: 1.45 K in temperature, 0.39 m s−1 in wind speed, and 14° in wind direction compared with the BOBMEX buoy observation, and 1.43 m s−1 in wind speed, 43° in wind direction, and 0.75% in relative humidity compared with the CONTROL. The impact of SDA over land and sea compared with SDA over land only showed a further marginal reduction of errors: 0.23 K in air temperature (BOBMEX buoy) and 1.33 m s−1 in wind speed simulations.