Abstract
The path scanning methods frequently use in the large area inspection. The inspection accuracy is easy affected by the inclination of the inspection target when the inspection area is too large (length>100mm). It will result to the defocus of captured image and enlarge the inspection results. In conventional, the additional sensor or focus associated device is used to maintain the focus status of lens during the inspection or measurement. In usually, the additional devices are expensive and it doesn’t suit each application. In this paper, the imaging base autofocus method was used to measure the 2 dimensional inclinations. And this paper presents a numerical method to compensate the scanning path. It can decrease the defocus status during scanning or measurement. The presented method based on the existed 3 axis optical inspection system, it didn’t need additional device or component. It will improve the inspection accuracy and doesn’t increase the system cost.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
