The Development of a Processing Window for the Continuous Galvanizing of a Mn–Cr–Si Martensitic Steel

Abstract

AbstractMartensitic or complex phase steels are leading candidates for automotive impact management applications. However, achieving high strengths while obtaining high quality coatings via continuous galvanizing is a challenge due to cooling rate limitations of the processing equipment and selective oxidation of alloying elements such as Cr, Mn, and Si adversely affecting reactive wetting. The galvanizability of a CrMnSi steel with a target tensile strength above 1250 MPa was investigated within the context of the continuous galvanizing line. The continuous cooling transformation behavior of the candidate alloy was determined, from which intercritical and austenitic annealing thermal cycles were developed. The evolution of substrate surface chemistry and oxide morphology during these treatments and their subsequent effect on reactive wetting during galvanizing were characterized. The target strength of 1250 MPa was achieved and high quality coatings produced using both intercritical (75% γ) and austenitic (100% γ) annealing using a conventional 95%N2–5%H2, −30°C dew point process atmosphere and 0.20 wt% dissolved (effective) Al bath, despite the presence of significant Mn and Cr oxides on the substrate surfaces. It is proposed that complete reactive wetting by the Zn(Al, Fe) bath was promoted by in situ aluminothermic reduction of the Mn and Cr‐oxides by the dissolved bath Al.