The determination of thermal residual stresses in unidirectional and cross-ply titanium matrix composites using an etch removal method

Abstract

Recent work has shown that a simple rule-of-mixtures approach may be used to predict the stress–strain behaviour of a cross-ply metal matrix composite laminate. However, the low-strain behaviour was not predicted accurately, probably because thermal residual stresses are obviously not included in such an approach. To increase the understanding of the limitations of the rule-of-mixtures approach for predicting the stress–strain response, the residual strain-state of the fibre reinforcement has been determined using an etching technique (henceforth referred to as the ‘total etch removal method’), and results have been compared both with finite element modelling and with thermal residual strain measurements derived from stress–strain curves. The results show that the residual strain distribution in a cross-ply composite may be more complex than previously thought, with the fibres in internal 0° plies having considerably higher thermal residual strains than fibres in external plies. The results confirm that the rule-of-mixtures approximation can be used, with some reservations with regard to the low-strain behaviour.