The determination of tellurium by nondispersive atomic fluorescence spectrometry using the hydride generation technique

Abstract

Atomic fluorescence spectrometry with a nondispersive measuring system is combined with a hydride generation technique for the determination of tellurium. Atomic fluorescence measurement is based on the reduction of tellurium by either metallic zinc or sodium borohydride, introduction of the generated tellurium hydride into a premixed argon (entrained air)-hydrogen flame, and excitation with a tellurium electrodeless discharge lamp. The comparison of the zinc and the sodium borohydride reduction methods is discussed in terms of detection limit, precision and interference. The best attainable detection limits for tellurium are 2ng (0.1 ng ml ) and 30 ng (1.5 ng ml ) with the zinc and the sodium borohydride methods respectively. Analytical working curves obtained from peak-height and peak-area measurements are linear over a range of approximately 4 orders of magnitude. Of the mineral acids examined in the range up to 2.0 m. nitric acid gives a depressing interference in the range greater than 0.5 m in the zinc method, whereas all of the acids greater than 1.0 m give a slight enhancement of the signal in the sodium borohydride method. The presence of several elements including other hydride-forming elements in 1000-fold ratio to tellurium causes a depressing interference, while enhancing interferences from tungsten and vanadium are observed in the zinc and the sodium borohydride methods, respectively. The present system coupled with the zinc method has been applied to the determination of tellurium in several samples of high-purity copper metal after separation of the analyte from copper by passing an ammoniacal solution of the sample through Chelex-100 resin. The results are in good agreement with those obtained by graphite furnace atomic absorption spectrometry.