The design and performance of a prototype water Cherenkov optical time-projection chamber

Abstract

A first experimental test of tracking relativistic charged particles by ‘drifting’ Cherenkov photons in a water-based optical time-projection chamber (OTPC) has been performed at the Fermilab Test Beam Facility. The prototype OTPC detector consists of a 77cm long, 28cm diameter, 40kg cylindrical water mass instrumented with a combination of commercial 5.1×5.1cm2 micro-channel plate photo-multipliers (MCP-PMT) and 6.7×6.7cm2 mirrors. Five MCP-PMTs are installed in two columns along the OTPC cylinder in a small-angle stereo configuration. A mirror is mounted opposite each MCP-PMT on the inner surface of the detector cylinder, effectively increasing the photo-detection efficiency and providing a time-resolved image of the Cherenkov light on the opposing wall. Each MCP-PMT is coupled to an anode readout consisting of thirty 50Ω microstrips. A 180-channel data acquisition system digitizes the MCP-PMT signals on one end of the microstrips using the PSEC4 waveform sampling-and-digitizing chip operating at a sampling rate of 10.24Gigasamples-per-second. The single-ended microstrip readout determines the time and position of a photon arrival at the face of the MCP-PMT by recording both the direct signal and the pulse reflected from the unterminated far end of the strip. The detector was installed on the Fermilab MCenter secondary beam-line behind a steel absorber where the primary flux is multi-GeV muons. Approximately 80 Cherenkov photons are detected for a through-going muon track in a total event duration of ~2ns. By measuring the time-of-arrival and the position of individual photons at the surface of the detector to ≤100ps and a few mm, respectively, we have measured a spatial resolution of ~15mm for each MCP-PMT track segment, and, from linear fits over the entire track length of ~40cm, an angular resolution on the track direction of ~60mrad.