The Design and Numerical Study of a 2MWh Molten Salt Thermocline Tank

Abstract

Abstract The two tank molten salt thermal storage system is widely used in the commercialized solar thermal power plant. However, the thermocline storage system with a low-cost filler material is a more economically feasible option. In this study, a transient two-dimensional and two-temperature model is developed to investigate the heat transfer and fluid dynamics in a molten salt thermocline thermal storage system. After model validation, the effects of inlet flow boundary condition and storage medium properties including fluid and solid materials on the thermal performance of thermocline storage system are investigated. The results show that thermoclne thickness increases slowest with solar salt as heat transfer fluid (HTF) and Cofalit® as solid material in the thermocline tank. Any non-uniformity in the inlet velocity flow would only enhance mixing and widen the thermocline appreciably, which contributes to the loss of thermodynamic availability of stored energy. The thermocline thickness increases with the non-uniformity of the inlet velocity boundary condition. So smaller non-uniformity of inlet flow is better in non-uniform flow though it may causes larger fluctuations in average outlet temperature. Smaller inlet mass flow rate is better for the thermocline storage tank, while it also causes smaller discharging power. With the chosen basic design parameters such as fluid and solid materials, the size of a 2MWh thermocline tank is determined by a simple one-dimensional design method. Tank with larger H/D ratio has higher discharge efficiency. It helps to figure out the thermal stratification mechanism of a storage tank and thereby to determine optimum design and operating conditions.