The design and characterisation of sinusoidal toolpaths using sub-zero bioprinting of polyvinyl alcohol

Abstract

Sub-zero (°C) additive manufacturing (AM) systems present a promising solution for the fabrication of hydrogel structures with complex external geometry or a heterogeneous internal structure. Polyvinyl alcohol cryogels (PVA-C) are promising tissue-mimicking materials, with mechanical properties that can be designed to satisfy a wide variety of soft tissues. However, the design of more complex mechanical properties into additively manufactured PVA-C samples, which can be enabled using the toolpath, is a largely unstudied area. This research project will investigate the effect of toolpath variation on the elastic and viscoelastic properties of PVA-C samples fabricated using a sinusoidal toolpath. Samples were fabricated using parametric variation of a sinusoidal toolpath, whilst retaining the same overall cross-sectional area, using a sub-zero AM system. To mechanically characterise the samples, they were tested under tension in uniaxial ramp tests, and through dynamic mechanical analysis (DMA). The elastic and viscoelastic moduli of the samples are presented. No correlations between the parametric variation of the design and the Young's modulus were observed. Analysis of the data shows high intra-sample repeatability, demonstrated robust testing protocols, and variable inter-sample repeatability, indicating differences in the printability and consistency of fabrication between sample sets. DMA of the wavelength samples, show a frequency-dependent loss moduli. The storage modulus demonstrates frequency independence, and a large increase in magnitude as the sample increases to 3 wavelengths.