The Deformation and Cooling of Ceramic Particles Sprayed with a Thermal Radio-Frequency Plasma under Atmospheric Conditions

Abstract

Common thermal-spray techniques use the strong acceleration of powder particles to produce dense ceramic coatings with high bond strength. The residence time of the powder particles within the plasma jet is correspondingly low, and only relatively small particles can be molten. In this work, on the contrary, an inductively coupled radio-frequency (RF) inductively coupled plasma (ICP) torch was used to spray large oxide-ceramic powder particles under atmospheric conditions. The slow plasma flow of a RF plasma leads to large residence times of the powder particles, so that the powder size of the feedstock can be 100 µm and more. It was observed that these particles will not be strongly accelerated in the plasma and that their velocity at the moment of impact is in the range of 10 to 20 m/s. Ceramic coatings were ICP sprayed with a low porosity and a high bond strength, similar to direct current (DC) or high-velocity-oxygen-fuel (HVOF) sprayed coatings. The morphology of ICP-sprayed particles on smooth steel surfaces, as a function of the surface temperature, is described and compared with DC plasma-sprayed splats. Furthermore, the degree of deformation was measured and determined by different models, and the pronounced contact zones formed between the pancake and the substrate were investigated. The ICP-sprayed ceramic coatings show some special properties, such as the absence of metastable crystalline phases, which are common in other spray technologies.