Abstract

The Proton Induced X-ray Emission (PIXE) technique is a reliable ion beam analytical tool for the characterization of thin aerosol samples, but it can underestimate the lightest measurable elements (such as Na, Mg, Al and Si) owing to the absorption of their X-rays inside the sample. The Proton Induced Gamma-ray Emission (PIGE) technique could be employed as avalid means to determine corrections for such an effect. Hence, in this study, Fine (PM2.5) and Coarse (PM10–2.5) particulate matter samples collected at Ikeja, Lagos-Nigeria, using a double staged ‘Gent’ stacked sampler were analyzed for their elemental concentrations using an external beam set-up for simultaneous PIXE and PIGE measurements. The measured PIXE concentrations as well as the PIGE correction factors for Na and Al detected in the PM10–2.5 samples (collected on polycarbonate Nuclepore membranes) are reported. The concentrations of 24 elements (Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Ni, Cu, Zn, Se, Br, Rb, Sr, Zr, Cs and Pb) detected in both fractions were displayed, discussed and likely sources of these elements were also identified.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.