Abstract

Betamethasone (BTM)-loaded microparticles prepared by a spray drying method using chitosan (CTS) as raw material, type-A gelatin and ethylene oxide-propylene oxide block copolymer (Pluronic F68) as modifiers. The BTM-loaded in varied chitosan/Pluronic F68/gelatin microparticle formulations was investigated. By properly choosing excipient type and concentration a high degree of control was achieved over the physical properties of the BTM-loaded microparticles. Microparticle characteristics (zeta potential, tap density, particle size and yield), loading efficiencies, microparticle morphology and in-vitro release properties were examined. Surface morphological characteristics and surface charges of prepared microparticles were observed by using scanning electron microscopy (SEM) and microelectrophoresis. A SEM micrograph shows that the particle sizes of the varied chitosan composed microparticles ranged from 1.1-4.7 μ m and the external surfaces appear smooth. The BTM-loaded microparticles entrapped in the chitosan/Pluronic F68/gelatin microparticles with trapping efficiencies up to 93%, collected yield rate 44%, and mean particle size varied between 1-3 μ m, positive surface charge (20-40 mv), and tap densities (0.04-0.40 g/cm3) were obtained. The collected BTM yield and size of particle was increased with increasing BTM-loaded amount but both zeta potential and tap density of the particles decreased with increasing BTM-loaded amount. The in vitro release of BTM showed a dose-dependent burst followed by a slower release phase that was proportional to the drug concentration in the concentration range between 5-30%w/w. The in vitro drug release from the chitosan/Pluronic F68/gelatin 1/0.1/0.4 microspheres had a prolong release pattern. These formulation factors were correlated to particulate characteristics for optimizing BTM microspheres in pulmonary delivery.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.