Abstract
The casting process design and simulation of the volute of 65ZGB slurry pump were presented in this paper. The casting process design principle, process parameters, points of attention, and the simulation parameters were introduced. Huazhu CAE was used to simulate the casting process. The STL document used in Huazhu CAE was converted from the 3D moulding of the casting process using the Solidwork software. The simulation results and practical production showed that the casting process can reduce shrinkage defects of the casting.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
