Abstract
The research on tolerance stress in aluminum alloys is focused on examining the mechanical behavior of τ4-Al3FeSi2 and τ12-Al3Fe2Si phases during [001] compression and their structural evolution. The use of MD computational bond length measurements allows for a comparison to be made with previous studies on tensile deformation. The simulations were performed at a constant strain rate of 21×1010 s-1, using NPT conditions (isothermal-isobaric), with approximately 20,000 atoms, 1 atmosphere of pressure, and 300 K temperature, using a Nosé-Hoover thermostat. Under periodic boundary conditions, the Modified Embedded Atoms Method (MEAM) potential was applied to all 3D faces, and the average bond length behavior between Al, Fe, and Si was calculated. A comprehensive investigation is carried out to explore the properties of these phases, including a detailed structural analysis at the atomic scale. This paper presents a comprehensive analysis of how changes in compound concentration affect mechanical behavior during compression. The average bond length varies depending on the applied stress axis, and it demonstrates good agreement with literature data. The mechanical deformations alter the behavior of atomic phases, as discussed in detail in the conclusion.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Engineering Research in Africa
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
