Abstract
This paper proposes a new method of automatic detection and elimination of cutter gouging when using the fillet-end milling cutter to produce a complex surface on the five-axis computer numerical control machine tool. To avoid local cutter gouging at the point where the cutter and part surface make contact with each other, the method of exact curvature matching between the cutter and part surface is presented. The size of cutter radii is more easily determined by this method. To detect if a rear cutter gouging occurs near the contact point, a square grid with horizontal and vertical points is used for illustrating the checking area and checking points. The technique of automatic generation of the square grid points and the method of detection and avoidance of rear cutter gouging are investigated throughout this article. In the end, the studied methodology and algorithms are inspected and verified by using an example of nonuniform rational B spline surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.