Abstract
PECVD silicon nitride passivation is quite frequently done at the end of AlGaN/GaN HEMT fabrication before substrate back-side lapping. However, the PECVD silicon nitride process is likely to produce pinholes in the passivation film. A very thick PECVD silicon nitride film may produce mechanical stress on the underlying device. Polyimide passivation has also been known to be effective for AlGaN/GaN HEMT and it can also serve as a stress buffer. However, polyimide can take up water while PECVD silicon nitride is a good diffusion barrier for water, etc. Thus it is expected that a dual PECVD silicon nitride/polyimide passivation will be a better choice than just a single layer of PECVD silicon nitride or polyimide. In this paper, we will demonstrate the application of a dual PECVD silicon nitride/polyimide passivation to AlGaN/GaN HEMT process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.