Abstract
In high-precision fiber-optic gyroscope (FOG) system, the spike noise of DC-DC power source can lead to a considerable disturbance to the signal processing circuit of FOG, which results in a sampling error. In this work, the cause of spike noise and the influence mechanism were clarified. The slew rate control technology was researched and proved to be an effective solution to prevent spike noise of FOG power source. Using slew rate control technology, a kind of low-noise power module has been developed and applied successfully in the FOG system. This power module consists of DC-DC circuit and LDO circuit, and slew rate control circuit was used in the DC-DC circuit to realize low-noise performance. The peak-to-peak noise value of the developed power module was tested to be about 1 mV in a bandwidth of 200 MHz. Two typical FOG systems were tested with the use of this low-noise power source, and their output noise improvement were 3.1% and 4.4%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
