Abstract
Thermal residual plastic deformation of bond joints on thin film based DWDM module under thermal cycles loading was investigated using three-dimensional finite element analysis. Finite element simulations were carried out to investigate the effect of the 4 and 6 solder-joint designs for the metal tube with 0.1 mm alignment offset. It was found that 6-solder joint requires more thermal cycles to arrive a stable tilt angle. The transverse movement of metal tube under thermal loading was also examined to determine the influence of solder volume imperfections and solder materials. Favorable results were obtained for 80Au20Sn solder as compared to 63Sn37Pb solder. From the thermal-elasto-plastic analysis, the solder volume control has great impact on the metal tube movement and tilt angle during thermal loadings. If adequate solder volume is provided in four solder joints, the minimum alignment shift of the metal tube is projected to be comparable to an optimally designed bond joint geometry.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
