The 3d response of a large-scale masonry arch bridge - part I: Performance under low and medium loading levels

Abstract

Masonry arch bridges are characterised by three-dimensional (3D) behaviour when subjected to external eccentric loading (e.g., vehicle loads). The arch ring, abutments, backfill and spandrel walls may interact with each other in a complex manner, leading to a 3D mode of response that can have a significant impact on the initiation and propagation of damage. However, there is a dearth of experimental data from tests designed to investigate the 3D behaviour of masonry arch bridges, particularly under loading levels below those required to cause failure. This paper presents results from tests on a large-scale brickwork masonry arch bridge subjected to low- and mid-level static loads under laboratory conditions. Point loads of increasing magnitude were applied at different locations on the top of the backfill in order to investigate 3D response and damage accumulation. Details of the experimental setup, material characterisation, and the results obtained from static and repeated load tests at low- and mid-level load magnitudes are presented herein. Results demonstrate that the bridge exhibited a 3D mode of response under eccentric point loads. Loading at the mid-span resulted in greater deformation of the arch barrel compared to loading at the quarter- and three-quarter-span points, due to the shallower backfill depth over the crown. Under the mid-level loading, stiffness degradation was observed during the testing regime, suggesting an accumulation of damage in the bridge. Moreover, when loading was applied close to a spandrel wall, measurable out-of-plane deformation of the spandrel wall was observed, with this deformation increasing significantly as the load was increased from 150 kN to 250 kN. This results from a combination of increased lateral soil pressure and decreased shear resistance at the arch-spandrel wall interface.