Abstract
Testing of the lifetime of hydrostatic transmissions can be done on special testing stands. Some testing stands use a pressure valve connected at the outlet of a pump. When using this design of stands, it is important to keep clear the operating fluid by filters and it is not possible to observe the influence of fluid pollution on the lifetime. The article presents a design of an electro-hydraulic testing stand with computer control system for accelerated lifetime tests of hydrostatic pumps under laboratory conditions when using a polluted operating fluid. A pump, which is mechanically connected with a hydrostatic motor, through a clutch, is an interface between the hydrostatic circuit of the tested pump and the hydrostatic circuit of the loading simulator. At lifetime testing, this interface makes it possible to use the polluted fluid in the hydraulic circuit of the tested pump, and thereby observe its influence. Instead of a polluted fluid, it is possible to use biodegradable oil and observe its influence on the lifetime of a pump. When using the same hydraulic fluid in both systems of the stand, it is possible to test two pumps at the same time.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.