Abstract

the manual assembly line used for assembling a certain type of lighting panel was introduced. The manual assembly works were analyzed. The assembly workbench surface illumination of the assembly line was tested. According to the light source is linear form, the assembly workbench surface was divided into some rectangles firstly. The intensity of illumination of these rectangles centers were tested by the illuminance meter. The average illuminance was also calculated out. According to these values, the illuminance curves were draw, which were approximately parallel lines. Further, the time values of the workers complete the same assembly work in different illumination were measured. The analysis reveals that the high illumination or the low level of illumination will affect the work efficiency. The reasonable illumination interval values were found. The testing and analysis provide scientific basis for the adjustment of the workbench illuminance and the improvement of working environment lighting.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.