Abstract
A new low-cost test method for analog integrated circuits, called the oscillation test, is presented. During the test mode, the circuit under test (CUT) is converted to a circuit that oscillates. Faults in the CUT which deviate the oscillation frequency from its tolerance band can be detected. Using this test method, no test vector is required to be applied. Therefore, the test vector generation problem is eliminated, and the test time is very small because only a single output frequency is evaluated for each CUT. The oscillation frequency may be considered as a digital signal and therefore can be evaluated using pure digital circuitry. These characteristics imply that the oscillation-test strategy is very attractive for wafer-probe testing as well as final production testing. In this note, the validity of the proposed test method has been verified throughout various examples such as operational amplifiers, amplifiers, filters, and analog-to-digital converters (ADCs). The simulations and practical implementation results affirm that the presented method assures a high fault coverage.
Submitted Version (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
