Testing Abrasion Resistance of High-Strength Concrete

Abstract

Abstract Several high-strength concrete types with compressive strength up to 120 MPa were tested to evaluate the suitabilities of two test standards to evaluate abrasion resistance of concrete subjected to wearing caused by heavy tire and steel wheel traffic and heavy trucking and water-borne debris. The selected tests were ASTM C 779, Procedure C, Test Method for Abrasion Resistance of Horizontal Concrete Surfaces, and ASTM C 1138, Test Method for Abrasion Resistance of Concrete (Underwater Method). Because of the low rate of abrasion damage of high-strength concrete, the need to prolong the test duration of the mechanical abrasion test from 20 to 40 min and that of the underwater test from 72 to 96 and 120 h to better differentiate between various levels of abrasion was evaluated. The study also evaluated the differences in wear damage resulting from testing the finished, molded, or saw-cut surfaces of high-strength concrete. Both ASTM procedures are found to be suitable for testing the abrasion resistance of high-strength concrete. The recommended test duration of 20 min and 72 h for the ASTM C 779 and C 1138 tests, respectively, are sufficient to differentiate between the levels of wear damage of high-strength concrete. Good correlations exist between the wear damage measured at 72 h and those determined at 48, 96, and 120 h for the underwater test and 10 and 20 min results for the mechanical abrasion test. The evaluation of the abrasion resistance of saw-cut surfaces can yield considerably lower abrasion damage and smaller variations in within-test results than testing finished or molded surfaces.