Test on seismic behaviors of stainless steel bolted extended end-plate beam-column joints

Abstract

This study conducted tests on the seismic behavior of austenitic stainless steel bolted extended end-plate beam-column joints, which have been few reported. Considering the influence of material type, end-plate thickness, bolt diameter, panel zone thickness, and loading scheme, 11 stainless steel joints and two carbon steel joints were designed and tested. Material properties, joint failure modes, moment-rotation curves, bolt load distributions, and joint component yield sequences were reported in detail. Experimental research showed that the beam-column joints in austenitic stainless steel experienced four failure modes, i.e. plastic hinge at the beam end, fracture failure of weld between the beam flange and end-plate, bolt rupture failure, and composite failure. All the tested joints had good seismic behavior, with rotation capacity greater than 0.03 rad. The influence of joint configurations on the seismic behavior were analyzed. The results indicated that the end-plate thickness, end-plate stiffener, and bolt diameter had a substantial impact on the joint seismic behavior, while the thickness of column web in panel zone, material properties, and loading scheme had a comparatively small effect. The initial rotational stiffness and moment resistance(yield moment) of joint obtained from the experiment were compared with the predictions of the EN1993-1-8, Design Guide 16, and JGJ 82-2011. Comparisons indicated that the EN1993-1-8 overestimated the initial rotational stiffness; Both the EN1993-1-8 and JGJ 82-2011 underestimated the moment resistance, while the predictions from the Design Guide 16 were significantly higher than the moment resistance and closer to the ultimate moment.