Abstract
A cryocooler-cooled high-temperature superconducting magnet was constructed, and it was tested on the beam line of the heavy ion medial accelerator in Chiba (HIMAC). The magnet consists of a pair of four-stacked racetrack coils wound with RE-123 coated conductor that are plated with 41- μ m copper for protection. The magnet has a room temperature beam duct, at which 2.4 T of magnetic field is generated, whereas the maximum magnetic field to which coated conductors are exposed is approximately 4 T. The magnetic field in the beam duct was measured and calculated to examine its stability, which might have been affected by shielding currents in the coated conductors. On the beam line of the HIMAC, at first, the beam guiding by the magnet was demonstrated. The measured beam-guiding characteristics were compared with the beam tracking calculations. Next, a carbon ion beam was injected intentionally into the RE-123 coils of the magnet to simulate the incidents of uncontrolled beam injection into accelerator magnets. Prior to this test, the possible heat deposition to the coil by the beam injection was calculated, and the feasibility of quench protection using a dump resistor was studied through quench experiments using short pieces of the RE-123 coated conductors.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.