Terrestrial heat flow in Japan

Abstract

Terrestrial heat flow, Q=K×ΔT/ΔZ cal/cm2 sec has been determined at 51 localities (39 on land and 12 in the sea) in and around the Japanese Islands. The average values of observed heat flow in land and sea are 1.53µ cal/cm2sec and 1.48µcal/cm2sec respectively. These value do not differ greatly from the world’s averages. The outstanding features of the heat flow distribution are as follows:a) High heat flow region (Q>2.0µcal/cm2sec) exists in the Inner Zone of the Honshu Arc. This region of high heat flow is more distinct in the northeastern Japan than in the southwestern Japan.b) The High heat flow region seems to extend, through the Fossa Magna area, down to the Izu-Mariana Arc.c) It is also probable that a similar high heat flow zone exists in the inner side of the Kurile Arc.d) These zones of high heat flow precisely coincide with the zones of the Cenozoic orogeny in the area concerned.e) Far off the coast of the northeastern Japan, the area at about 150° E may be a high heat flow region.f) Low heat flow (Q<1.0µcal/cm2sec) prevails in the Pacific coast side of the northeastern Japan and in the oceanic area directly east of it, including the area of the Japan Trench.g) The region bounded by the above mentioned high and low heat flow regions has heat flow which is more or less normal. Based on these measurements, a « steady state ” temperature distribution in the crust has been calculated for each of the above regions of high, low and intermediate heat flow, and it was found that there is a large temperature differences between the bottom of the crust of the high and low heat flow regions: the temperature at the Moho boundary in the high heat flow regions should be as high as some 800∼1000°C (d=27 km), whereas that under the low heat flow region should be only about 200°C (d=23 km). The high general temperature at the Moho under the high heat flow region seems to favor a production of magma in the upper mantle. Calculated Moho temperatures disfavor the hypothesis that the Moho boundary is due to phase transition.