Tensile performance of aluminum alloy roof panel-member clamp connection

Abstract

In aluminum alloy reticulated shell structures with gusset joints, the roof panel is effectively connected with the structural members through a clamp connection, enabling the roof panels to participate in the force resisting system. The performance of the connection between the roof panels and the members is the foundation for studying the collaborative action of the roof panels and the members. Relevant studies have shown that when the roof panels participate in the force resisting system, there is mainly a tensile force in the roof panels perpendicular to the axis of the members. Therefore, this paper experimentally studied the mechanical performance of the clamp connection between the roof panels and the members under the tensile force in the roof panels, and employed two-dimensional plane digital image correlation (DIC) to measure the deformation of the specimen section during the entire loading process, thus exploring the force transmission mechanism of the connection. The tensile capacity of the connection can be divided into four stages: roof panel sliding, roof panel tension–shear, lower limb bending of the strip, and roof panel bending stages. The mechanical index of the connection is primarily determined by the tension–shear stage of the roof panel, and the ultimate strength and stiffness can be determined as the peak load and linear segment stiffness of the connection at this stage. The refined finite element model was further established, and it was verified that the model could efficiently simulate the mechanical properties of the connection through comparison with the test. Parametric analysis shows that with an increase in the friction coefficient between materials, roof panel thickness, angle between roof panel and flange, and bolt length adjustment, the restraint on the roof panel increases, and the failure mode of the clamp connection changes. Based on the parametric analysis, the recommended values of the friction coefficient between the materials, minimum panel thickness, minimum bolt screw depth, and maximum bolt spacing are provided. Finally, combined with the theoretical analysis, calculation formulas for the tensile strength and stiffness of the connection were proposed. A comparison with the test results indicates that the prediction accuracy of the formula proposed in this study is good.