Abstract
Neutron-irradiated specimens of the reduced-activation tempered martensitic steel EUROFER97 were tested by tensile and low cycle conditions to detect the impact of irradiation on strength and lifetime. The irradiation temperature ranged from 523 to 723K with an accumulated dose of up to 16.3dpa. Tensile tests revealed a significant irradiation-induced hardening below 673K with a peak of ∼430MPa at 573K but none was seen at 723K, as expected. Despite the significant irradiation-induced reduction of uniform elongation, the total elongation is only reduced by about 50% below 673K. Post-irradiation strain-controlled fatigue tests have been carried out at Tirrad=Ttest=523, 623 and 723K. Pronounced cyclic softening was observed in all specimens. At 623 and 723K, neutron irradiation had no effect on fatigue life within the data scatter. A significant lifetime increase has been observed at Tirrad=Ttest=523K that advances with decreasing stress amplitude Δε (1%→0.5%) up to a factor of ten. Scanning electron microscopy (SEM) analysis revealed ductile fracture and fatigue striations on the fracture surfaces. After push–pull fatigue testing, transmission electron microscopy (TEM) investigations showed the typical sub-cell formation, even at Tirrad=Ttest=523K.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
