Abstract
Hot-boned broiler breast fillets were tightly clamped between rigid aluminum plates during chilling to determine whether tenderness is increased if breast fillets are not allowed to shorten during rigor. In two experiments, 6-wk-old broilers were processed in a pilot plant. Approximately 5 min after evisceration, the breast fillets (pectoralis major) were deboned, and each fillet was subjected to one of two treatments while chilling for 2 h in ice slush. Fillets were placed in perforated plastic bags (hot-boned control) or clamped between rigid aluminum plates that compressed the meat to a uniform thickness of 7.2 mm during chilling. In Experiment 2, chilling time in ice slush was 1 h, and a third treatment was added to make an incomplete block design in which one breast half was left intact on the carcass and was deboned immediately after chilling. All breast fillets were sealed in plastic bags after the chilling period, held overnight at 4 C, and then cooked at 85 C for 30 min in a steam kettle. In Experiment 1, clamping for 2 h reduced Warner-Bratzler shear values of hot-boned fillets from 11.4 to 2.7 kg. In Experiment 2, shear values for the treatments were 13.0, 9.2, and 5.1 kg for the hot-boned, cold-boned, and hot-boned clamped treatments, respectively, with significantly lower shear values for the clamped fillets. Clamped fillets were significantly thinner than the control fillets in both experiments. Cooked yield as a percentage of postchill weight was significantly higher for the clamped compared to the hot-boned control pieces, 81.1 versus 77.3%, with cold-boned pieces being intermediate and not different from the other treatments. Shear values were reduced, and cooked yield was increased by clamping hot-boned fillets during chilling.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.