Temperature-resistant high-infrared transmittance indium molybdenum oxide thin films as an intermediate window layer for multi-junction photovoltaics

Abstract

For optimal performance, the intermediate window layer in multijunction photovoltaics should transmit as much light as possible to guarantee maximum device efficiency. In this work, we demonstrate that indium molybdenum oxide (IMO) is a more suitable intermediate layer, compared to indium tin oxide (ITO), as it would absorb significantly less infrared light with comparable electrical conductivity once integrated into a multijunction solar cell. In fact, we show that IMO optoelectronic properties are virtually unchanged by the typical thermal budgets used in solar absorber deposition processes used in low-cost high-performance multijunction photovoltaics (e.g. CuInGaSe2). Specifically, IMO and ITO thin films were reactively sputtered onto glass substrates at 150°C, then subjected to a vacuum annealing process (550°C, 2h) identical to that of co-evaporated copper gallium diselenide (CGSe), a candidate material for the top absorber in multijunction cells. We found that annealing substantially reduces the infrared transmittance of ITO starting at 900nm, reducing by 2.5% per 100nm, while IMO only started experiencing a reduction at 1400nm and decaying more slowly at 1.6% per 100nm. Furthermore, the resistivity of IMO was comparable to that of ITO after annealing. The resilience of IMO to such high temperature processes show that it has potential to enhance the performance of multijunction devices.