Abstract
In high-temperature working conditions, the temperature difference between parts is common, and it is necessary to perform a temperature gradient test to predict creep behavior of alloy in real working conditions. In this study, a novel temperature gradient creep (TGC) test aided by an image processing method (IPM) was designed and performed on 2024-T3 aluminum alloy. The tests were performed under the conditions of isothermal tensile creep (ITC) and TGC in the temperature range of 285–315 °C under two stresses of 90 MPa and 125 MPa. Several experimental investigations were conducted to evaluate the creep failure of the specimens. The results showed that the temperature gradient during the TGC test leads to changes in strain, strain rate, stress exponent, microstructure and damage amount in the samples. The creep strain and strain rate of the TGC are greater than those of the ITC at 300 °C and 285 °C, and the rupture life is shorter. Finally, the Larson–Miller parameter is calculated, and the mathematical relationships between the strain rates of the TGCs and ITCs in 90 MPa and 125 MPa, which can be used to predict the creep strain rate under isothermal conditions, are proposed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
