Abstract

It is well known that temperature acts negatively on practically all the parameters of photovoltaic solar cells. Also, the solar cells which are subjected to particularly very high temperatures are the light concentration solar cells and are used in light concentration photovoltaic systems (CPV). In fact, the significant heating of these solar cells is due to the concentration of the solar flux which arrives on them. Light concentration solar cells appear as solar cells under strong influences of heating and temperature. It is therefore necessary to take into account temperature effect on light concentration solar cells performances in order to obtain realistic results. This one-dimensional study of a crystalline silicon solar cell under light concentration takes into account electrons concentration gradient electric field in the determination of the continuity equation of minority carriers in the base. To determine excess minority carrier’s density, the effects of temperature on the diffusion and mobility of electrons and holes, on the intrinsic concentration of electrons, on carrier’s generation rate as well as on width of band gap have also been taken into account. The results show that an increase of temperature improves diffusion parameters and leads to an increase of the short-circuit photocurrent density. However, an increase of temperature leads to a significant decrease in open-circuit photovoltage, maximum electric power and conversion efficiency. The results also show that the operating point and the maximum power point (MPP) moves to the open circuit when the cell temperature increases.

Highlights

  • The principle of light concentration photovoltaic systems (CPV) is to concentrate, using parabolic mirrors or Fresnel lenses, the sunlight on a PV cell, to obtain higher conversion efficiency than those classic cells

  • Dimroth et al [3] worked on four-junction solar cell of the GaInP/GaAs//GaInAsP/GaInAs type and showed that an increase of light concentration leads to an increase of open-circuit photovoltage, fill factor and conversion efficiency which reaches a value of 44.7% under C = 297 Suns

  • Our study model is a silicon solar cell illuminated by a concentrated light under temperature influence as shown in Figure 1 below

Read more

Summary

Introduction

The principle of light concentration photovoltaic systems (CPV) is to concentrate, using parabolic mirrors or Fresnel lenses, the sunlight on a PV cell, to obtain higher conversion efficiency than those classic cells This process, which is more recent, uses cell technologies which are more expensive and more efficient than conventional cells [1]. These technologies used for space applications, must be installed in places which have a strong direct sunshine and require trackers to follow the course of the sun and collect as much direct light as possible [1] [2] Among these light concentration solar cells, those which use multispectral conversion technology allow highest efficiency to be obtained [2].

Excess Minority Carriers’ Density
Photocurrent Density
Junction Photovoltage
Conversion Efficiency
Temperature Effect on Diffusion Parameters
Temperature Effect on Photocurrent Density
Temperature Effect on Photovoltage
Effect of Temperature on Electric Power
Temperature Effect on Conversion Efficiency
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call