Temperature-Dependent Reflectance of Copper with Different Surface Conditions Measured at 1064 nm

Abstract

AbstractIn order to fully understand and to eventually overcome the instabilities in laser welding of copper using 1064 nm wavelength lasers, it is important to get a deeper understanding about the interaction of the incident beam with the copper surface during the process. One of the main parameters determining this behavior is the temperature-dependent absorptance. However, the existing datasets only show little consistency between the different sources, do often not include the important absorptance step at melt temperature, or they are only calculated. This article thus presents an experimental approach to measure the reflectance of electro tough-pitch copper (Cu-ETP) from room temperature until beyond the melting point with an integrating sphere setup. The setup was developed with particular attention to measurement accuracy up to high temperatures. The reflectance using a 1064 nm laser under an incident angle of 12° has been measured for four different sample groups, which are untreated rolled copper, mechanically polished copper, oxide reduced copper and resolidified copper. The measurement results reveal significant differences in the temperature-dependent reflectance between the sample types and, for some types, also between the samples of the same type. This study investigates the origins of the most significant features in the reflectance curves and their potential impact on processing copper using NIR lasers.