Abstract
We report the temperature- and magnetic-field-dependent resistivity of MgB 2 sintered at high-temperature and high-pressure condition. The superconducting transition width for the resistivity measurement was about 0.4 K, and the low-field magnetization showed a sharp superconducting transition with a transition width of about 1 K. The resistivity in the normal state roughly followed T 2 behavior with smaller residual resistivity ratio (RRR) of 3 over broad temperature region above 100 K rather than reported T 3 behavior with larger RRR value of ∼20 in the samples made at lower pressures. Also, the resistivity did not change appreciably with the applied magnetic field, which was different from previous report. These differences were discussed with the microscopic and structural change due to the high-pressure sintering.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
