Abstract

The superplastic deformation behavior of quasi-single phase Zn-0.3 wt. %Al was investigated. A series of load relaxation and tensile tests was conducted at various temperatures ranging from RT (20 °C) to 200 °C. The recently proposed internal variable theory of structural superplasticity was applied. The flow curves obtained from load relaxation tests were shown to consist of contributions from interface sliding (IS) and accommodating plastic deformation. In the case of quasi-single phase Zn-0.3 wt.% Al alloy with an average agrain size of 1 μm, the IS behavior could be described as a viscous flow process characterized by a power index of Mg=0.5. A large elongation of about 1400% was obtained at room temperature and the strain rate sensitivity parameter was about 0.4. Although relatively large-grained (10 μm) single phase alloy showed a high value of strain rate sensitivity comparable to that of fine-grained alloy at very low strain rate range, IS was not expected from the analysis based on the internal variable theory of structural superplasticity at room temperature. As the temperature increased above 100 °C, however, the contribution from IS was observed at a very low strain rate range. A high elongation of ∼400% was obtained in a specimen of 10-μm-grain-size at 200 °C under a strain rate of 2×10−4/sec.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.