Tectonics of the Aegean block: Rotation, side arc collision and crustal extension

Abstract

A new tectonic model for the Aegean block is outlined in an effort to explain the widespread extension observed in this region. A key element in this model is the concept of “side arc collision” This term is used to describe the interaction of subducted oceanic lithosphere with continental lithosphere in a subduction arc in which oblique subduction occurs. In the Hellenic arc side arc collision is proposed for the northeast corner near Rhodes. The collision involves subducted African lithosphere, moving to the northeast almost parallel to the arc, with the continental mass of southwest Turkey. It affects the motion of the Anatolian-Aegean plate complex, but is not similar to continental collision since it occurs mostly at depth and involves only little, if any, of the shallow and rigid part of the continental lithosphere. The model assumes that Anatolia and the Aegean are part of one plate complex which undergoes counterclockwise rotation; if it were not for the side arc collision near Rhodes, the two blocks would exhibit similar deformation and might, in effect, be indistinguishable. At present, however, free and undisturbed rotation is possible only for the Anatolian block (excluding western Anatolia) where the motion is accommodated by subduction along the Cyprean arc. Further west the side arc collision inhibits this rotation along the subduction front. Still further west, undisturbed subduction along the central and western parts of the Hellenic arc is again possible and is well documented. On the other side of the Anatolian-Aegean plate complex, relatively free motion occurs along the North Anatolian fault zone including in the Aegean Sea. The combination of this motion in the north with the local obstruction of the rotation near Rhodes, must create a torque and a new pattern of rotation for the western part of the plate complex, thus creating a separate Aegean block. Since, however, the two blocks are not separated by a plate boundary, the Aegean block cannot move freely according to the new torque. Effective motion of the Aegean block relative to Europe and Anatolia, particularly in the north, is achieved through extension of the crust (lithosphere?). Thus the greatest amount of deformation (extension) is observed along the suture zone between the two blocks and, in particular, in the northeastern part of the Aegean block where motion relative to Anatolia must be greatest.