Abstract
The hot-pressing technology for the poplar particle /waste rubber powder composites was studied using the poplar particle and waste rubber powder as raw materials. Effects of waste rubber powder content, hot-pressing time, hot-pressing temperature, resin content and board density were analyzed. The hot-pressing technology was better than molding technology. The optimal technological parameters of hot-pressing technology were obtained as board density0.8g/cm³, resin content3%, hot-pressing temperature160°C, hot-pressing time 7min , waste rubber powder content 30%. The testing results showed that the mechanical performances of the poplar particle /waste rubber powder composites made by the hot-pressing technology could achieve the Chinese National Standard for particle board.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
