Abstract

The effect of the concentration of aluminum powder and technical carbon nanoparticles on the main physical and mechanical properties of nanocomposites based on high density polyethylene, low density polyethylene and an ethylene-hexene copolymer is considered. The optimal technological parameters of the reaction extrusion of nanocomposites vulcanized with sulfur and dicumyl peroxide have been determined. The influence of the type of polyolefin, fillers and crosslinking agents on the formation of isotropic nanocomposites during the production of sheet products has been investigated.

Highlights

  • The effect of the concentration of aluminum powder and technical carbon nanoparticles on the main physical and mechanical properties of nanocomposites based on high density polyethylene, low density polyethylene and an ethylene-hexene copolymer is considered

  • Эти технологические параметры тесно связаны между собой, так как с повышением температуры происходит снижение эффективной вязкости расплава полимерной матрицы, что способствует некоторому повышению числа оборотов шнека и сохранению давления экструзии

  • Установлен температурный режим материального цилиндра, число оборотов шнека, давление экструзии и показатель текучести расплава (ПТР) материала, при котором обеспечиваются сравнительно высокие значения разрушающего напряжения и относительного удлинения нанокомпозитов

Read more

Summary

Introduction

The effect of the concentration of aluminum powder and technical carbon nanoparticles on the main physical and mechanical properties of nanocomposites based on high density polyethylene, low density polyethylene and an ethylene-hexene copolymer is considered. ПЭВП: разрушающее напряжение 31,3 МПа, модуль упругости при изгибе 753 МПа, относительное удлинение 435%, плотность 946 кг/м3, показатель текучести расплава (ПТР) 3,6 г/10 мин., теплостойкость 119°С, температура плавления 131°С, степень кристалличности 80%. Влияние температурного режима материального цилиндра экструдера на основные физико-механические свойства нанокомпозитов на основе ПЭВП, ПЭНП и СЭГ.

Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call