Techno-economic assessment of decentralized polishing schemes for municipal water reclamation and reuse in the industrial sector in costal semiarid regions: The case of Barcelona (Spain)

Abstract

Listen

Translate article

This study demonstrates the techno-economic reliability of an innovative fit-for-use treatment train to boost municipal reclaimed water reuse fore industrial uses in the Barcelona Metropolitan Area (BMA). The relatively high conductivity (2090 μS/cm) and hardness (454 mg/L) of reclaimed water in the BMA (e.g. Water Reclamation Plant (WRP) of El Baix Llobregat, Barcelona, Spain), together with the restrictive water quality demands in industrial uses, claims for the implementation of advanced reclamation schemes based on desalination technologies such as reverse osmosis (RO). The study assesses the benefits of two potential pre-treatments of the RO stage: (i) ultrafiltration (UF) or (ii) an innovative high-performance nano-structured polymeric adsorbent (CNM); in which a permeability decline of 5% was observed when CNM was used as a pre-treatment, while a stable permeability of RO was found when was fed by the UF effluent. On the other hand, generic cost curves have been calculated for the technologies evaluated and were applied to estimate capital and operational expenditures (CAPEX and OPEX) for the scale-up in three different industrial sites (e.g., chemical, waste management and electro-coating industries). The economic assessment indicates that the use of municipal reclaimed water is economically competitive in front of the use of tap water in the BMA, providing savings between 0.13 and 0.52 €/m3 for the waste management industry and between 0.49 and 0.98 €/m3 for the electrocoating industry. On the other hand, the use of groundwater in one of the industrial sites and its relatively low cost implied that, although it is necessary a RO, the current cost of water is significantly lower.