Techniques for depth-selective, low-frequency eddy current analysis for SQUID-based nondestructive testing

Abstract

Conventional eddy current techniques are widely used for detection of surface-breaking cracks in metal structures. These techniques have limited success in the detection of deep, nonsurface-breaking flaws that require low frequency eddy currents, for which inductive pick-up probes have drastically reduced sensitivity. High resolution, Superconducting QUantum Interference Device (SQUID) magnetometers, which are very sensitive to do or low frequency magnetic fields, have been developed for detection of subsurface flaws. We have now extended SQUID NDE by utilizing a sheet inducer to produce an extended eddy current parallel to the surface in a conducting plate. The magnitude of the induced current density inside the plate reduces with the depth; however, the current component at a certain phase angle may increase with the depth. At a particular phase angle, the current density on the surface becomes zero, while the current inside the plate is large, so that the magnetic signal at that phase angle due to the surface structures can be minimized. With this method, we have detected simulated cracks in the sides of plugged holes in a thick plate, a hidden corrosion area in a specimen which consisted of two painted aluminum plates joined with sealant, as well as crack defects adjacent to fasteners in the second layer of lap joined aluminum plates. We present a theoretical model for simulation of the phase-related magnetic signal due to a flaw, which shows the relation between the phase angle and the depth of the flaw. The theoretical phase analysis is compared with the experimental results.