Abstract
In calibrating a water distribution system model, the model user usually adjusts pipe roughness (e.g., Hazen‐Williams C factor) or water use so that pressures and flows predicted by the model agree with values observed in the field. This paper presents formulas to assist the user in deciding whether to adjust C or water use and by how much. The key to using the formulas is to observe pressures in the system for at least two significantly different use rates. Such data are often collected during fire flow tests. A model is considered calibrated to the extent that it can predict the behavior of the water distribution system over a wide range of operating conditions and water use.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Water Resources Planning and Management
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
