Abstract
The TF coil of HL-3 consists of 20 D-shaped demountable bundles, and all their L-shaped center sections are bonded together as the center-post. To increase its overall rigidity to resist torsional loads and avoid de-bonding failure, the center-post is wrapped by an insulation cylinder with enough prestress. Additionally, the insulation cylinder needs to be of good dimensional precision because the CS coil is winded around it. This paper describes the results of the technical studies carried out during the development of the insulation cylinder, including material selection, parameter calculation, enlacing tests and curing tests.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
