Abstract
High deformation hardening, low thermal conductivity, high built-up edge tendency of austenitic stainless steels were the main factors that make their machinablity difficult. For determination of the suitable cutting parameters in machining austenitic stainless steel AISI 304 by PcBN cutting tools, the samples which were prepared to be used in the experiment, 300 mm in length and 60 mm in diameter, were dry machined in a numerical control lathe. During experiments, dry turning parameters, such as feed rate, cutting speed and cut depth were investigated. The suitable cutting speed and feed rate were determined according to workpieces surface roughness, cutting tools flank wear. Finally, cutting speed of 180 to 200 m/min, feed rate of 0.05 to 0.06 mm/rev and cut depth of 0.10 mm gave the satisfied results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
