Abstract
This paper presents the results and gained experiences from the Project Based Learning (PBL) of magnetic component design within a Power Electronics Course. PBL was applied during the laboratory exercises through a design-project task based on a boost converter test board. The students were asked to calculate the main boost converter’s circuit parameters’ capacitor C and inductor L, and then additionally required to design and build-up the inductor L, in order to meet the project’s goals. The whole PBL process relied on ideas from the CDIO (Conceive, Design, Implement, Operate), where the students are encouraged to consider the whole system’s process, in order to obtain hands-on experience. PBL is known to be a motivating and problem-centered teaching method that gives students the ability to transfer their acquired scientific knowledge into industrial practice. It has the potential to help students cope with demanding complexities in the field, and those problems they will face in their future careers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.